Back to Search Page
Resource Detail

Perencanaan dan pembuatan pengatur lampu dengan menggunakan remote RF yang berbasis mikrokontroler 8031 [permalink]

Share/Save/Bookmark

In this thesys, a device has been made which is intended to control the light
in a house from a far distance by using a RFsystem remote control.
In the remote there is asinusoidal signal generator. The frequency of the
signal is determine by an external resistor and some capasitors. The output frequency
can be change by changing the value of the capasitors. It can be done by using some
keypads, so we can determine the frequency we need. The signal are transmitted by a
transmitter.
There is a receiver catches these signals, and four unique work frequencies.
If a frequqncy gets into a tone decoder, matches with its work frequency, the tone
decoder will produce a low signal, otherwise it will be high. These tone decoder
outputs are conectted to the port I microcontroller 8031, so the program in the CPU
8031 can detect if there is a keypad in the remote control pushed.
Line signal is stepped down and rectified full wavely and conectted into a
zero crossing detector. If the line signal passes the zero volt, this zero crossing
detector will produce a short time high pulse. This pulse then conectted to a pre-interrupt
circuit, to created pulse which is match to 8031 interrupt condition.
To light on the lamp, the 8031 will produce a high pulse to the triac driver.
Laboratorium testing has shown, the power output of the lamp can be
conttrolled in ten power levels at range less than ten metres.

Author
• (23485046) RAEDIATMAJA INWAHJUDI

Contributor
• (61214) YOHANES T. D. S
• (93-021) IRWAN SAHLI
• (85-001) HERLIANTO TENGGARA

Publisher
Universitas Kristen Petra

Year : 1998

Subject
1. REMOTE CONTROL

Category
s1 - Skripsi/Undergraduate Thesis (Program Studi Teknik Elektro S1)

Language
Indonesian

Rights
Skripsi No. 98/E/EL/004/349; Raediatmaja Inwahjudi (23485046)
The resource(s) is/are owned by the Creator/Contributor.Reproduction & distribution for non-commercial purposes is permitted provided that the credit for the Creator/Contributor and the source are explicitly stated,and no alteration are made

FILE(s)

1. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-cover.pdf (321.67 kB) - [permalink]

2. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-abstract_toc.pdf (439.85 kB) - [permalink]

3. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-chapter1.pdf (206.97 kB) - [permalink]

4. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-chapter2.pdf (1.04 MB) - [permalink]

5. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-chapter3.pdf (801.19 kB) - [permalink]

6. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-chapter4.pdf (1.73 MB) - [permalink]

7. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-conclusion.pdf (180.98 kB) - [permalink]

8. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-references.pdf (156.94 kB) - [permalink]

9. jiunkpe-ns-s1-1998-23485046-14840-pengatur_lampu-appendices.pdf (980.85 kB) - [permalink]

 

Petra Christian University Library | library@petra.ac.id